UV LED Curing from Pinning to Final Cure

In digital printing, curing rarely happens in a single pass. Pinning units, positioned between colour stations, tack the ink at 2–10 W/cm² to hold dots in place before the next colour is laid down, while final curing at the end of the line runs at 24–30 W/cm². UVER supplies modules from 6 to 24 inches wide, with outputs ranging from 2 to 30 W/cm², and a portfolio spanning everything from pinning units to final cure systems.

Posted On
18th Nov 2026
Categories
Company, Curing, 2026 Q4
UV LED Curing from Pinning to Final Cure image

UVER has also developed an air-cooled curing unit delivering 30 W/cm² for wide-format UV inkjet printers and has begun supplying it to global printer manufacturers.

By nature, a UV LED emits light at a single peak wavelength, while many inks and coatings were formulated for a broad UV band. Because UVER's COB architecture mounts LED chips directly onto the board, chips of different wavelengths can be arranged side by side, producing a composite spectrum with wavelengths ranging from 245 nm to 430 nm, rather than a single peak at 395 nm. This broader spectrum allows UV LED systems to replace conventional lamps for a wide range of UV inks.

UV output also drifts gradually with temperature, operating hours and contamination, and spot-checking with a handheld meter is not enough to keep up. UVER's Intensity Auto Calibration System reads per-channel irradiance in real time, compares it against the setpoint and adjusts input power per channel across 1,204 steps, without stopping the press.

UVER performs COB packaging in-house in a Class 100 cleanroom and develops the optics, thermal structures, controllers and control software itself. Over 18 years, UVER has supplied more than 60,000 units and holds roughly 260 patents. OEM, ODM and fully customised builds are available.

For configurations matched to specific line widths and curing stages, contact [javascript protected email address].